Dual-XR-4110-Owners-Manual.pdf

(719 KB) Pobierz
INSTALLATION/OWNER'S MANUAL
AM/FM/MP3/WMA Receiver with Auxiliary Input,
USB Port and SD Card Input
XR4110
XR4110 INSTALLATION
Preparation
Please read entire manual before installation.
Before You Start
• isconnect negative battery terminal. Consult a qualified technician for instructions.
D
• void installing the unit where it would be subject to high temperatures, such as from
A
direct sunlight, or where it would be subject to dust, dirt or excessive vibration.
Getting Started
• nsert the supplied keys into the slots as shown, and slide the unit out of the mounting
I
sleeve.
• nstall mounting sleeve into opening, bending tabs to secure.
I
• onnect wiring harness and antenna. Consult a qualified technician if you are unsure.
C
• ertain vehicles may require an installation kit and/or wiring harness adapter (sold
C
separately).
• est for correct operation and slide into the mounting sleeve to secure.
T
• nap trim ring into place.
S
KEYS
MOUNTING SLEEVE
TYPICAL MOUNTING METHOD
2
XR4110 INSTALLATION
Wiring Diagram
Connect to amplifier RCA input
Rear Preamp Output
Antenna Connector
5 AMP
AGC Fuse
FUSE
When replacing the fuse,
make sure new fuse is the
correct type and amperage.
Using an incorrect fuse
could damage the radio.
The XR4110 uses one 5 amp
AGC fuse located in-line.
*
Caution - Do not attach any speaker leads to ground as severe damage will occur.
3
XR4110 OPERATION
Control Locations
1
2
3
4
5
6
7
16
15
14
13
12
11
10
9
8
1
2
3
4
5
6
7
8
Power / Source
Mute / Loud
Volume
Tune / Track Up
Band / Auto Station Store
SD Card Slot
Auxiliary Input
USB Port
9
10
11
12
13
14
15
16
Tune / Track Down
Preset 6
Preset 5 / Folder Up
Preset 4 / Folder Down
Preset 3 / Play / Pause
Preset 2 / Random
Preset 1 / Repeat
Audio / EQ
4
XR4110 OPERATION
General Operation
Power On/Off
Source
Press
 to
turn the unit on. Press and hold
than two seconds to turn the unit off.
for more
Press
SOURCE
to select between AM/FM, auxiliary input,
USB or SD Card modes. Modes of operation are indicated in
the display. SD and USB modes will not appear unless an
SD Card or USB device is connected.
Press and hold
LOUD
for more than 2 seconds to activate
and deactivate the loudness feature. Activating this feature
will enhance the bass and treble frequencies when listening
to music at low volumes.
Insert a 3.5mm connector in the front panel AUX port.
Connect the other end of the 3.5mm connector to the
headphone output of an audio device, MP3 player, etc.
Adjust volume using the volume knob (00-42).
Press
AUDIO to select between Bass, Treble, Balance and
Fader.
BASS
TREBLE
BALANCE
FADER
Loud
Auxiliary Input
Volume
Select Audio
Bass
Press
AUDIO
until
BASS
appears
Rotate the
volume knob left/right to adjust
(-7 minimum / 7 maximum)
Press
AUDIO
until
TRE appears
Rotate the
volume knob left/right to adjust
(-7 minimum / 7 maximum)
Press
AUDIO
until
B 00
appears
Rotate the
volume knob left/right to adjust
BL 15 (left) to BR 15 (right)
Press
AUDIO
until
F 00
appears
Rotate the
volume knob left/right to adjust
FR 15 (rear) to FF 15 (front)
Press
EQ
for more than two seconds to activate the first
preset EQ, then press and hold
EQ again to select between
POP, CLASSIC, ROCK and USER. Manual adjustments to the
bass and treble settings are saved as USER.
5
Treble
Balance
Fader
Preset EQ Curves
Zgłoś jeśli naruszono regulamin