Picking and decoding The NE78 Peugeot 406 lock(1).pdf

(740 KB) Pobierz
Picking and decoding The NE78 peugeot 406 lock
This was the very 1st 2in1 pick decoder made , and this was the 1st article i did on
the 2in1 tool for a uk magazine , im not sure if you come across this lock in the
states , but it has a nasty light clutch , but with the 2in1 tool is a simple pick and
decode.
UsingThe Lishi 2 in 1 Pick / decoder to pick and decode the prugeot 406 , NE78 Lock
The new range of Lishi 2 in 1 picks and decoders in 1 unit I really like. They are
neater than the old range, far easier to use with superb feedback, in fact the
superior feedback has made picking a whole lot easier. Below is one of the tools
from the range, The NE78 , 2 in 1 pick/decoder.
New Lishi 2 in 1 pick/decoder NE78 common on Peugeot 406.
The gauge with the wafer positions running right to left and the height lines to the right make
reading and positioning spot on every time.
PICKING THE LOCK
Insert the pick tool into the lock, once inserted, apply very very light tension, as in picture below;
line up the pointer to the 0 position on the grid, as in the picture 1 below, then gently push the wafer
manipulator up or down, on the unmarked line above the 0 position, as in picture 2 below.
Picture 1
Picture 2
If wafer resistance is felt the pick is correctly inserted, if no wafer resistance is felt at all then the pick
is upside down, turn pick over and repeat above test.
Once wafer resistance is felt, you need to reapply your light tension, position the picks pointer on
position 0 and gently push the wafer manipulator up or down slowly on the unmarked line opposite
the 0, until you feel a little light jump, verify wafer is picked by gently depressing the manipulator
down and you will feel it move and spring back, much like a picked lever in a mortice lock, it will feel
springy to the touch.
Keep your very light tension on and slide the pointer to position 9 on the gauge as in picture below.
Push the wafer up or down gently on the unmarked line opposite the 9 until springy as with 0
position, pictured below;
repeat the process for each position from 0 down to position 1
picking all 10 wafers, do not get tempted to apply more tension at this point, as if not fully picked the
clutch will engage rather than the lock open, as in picture 1, picture 2 shows the lock open.

Plik z chomika:

Inne pliki z tego folderu:

Inne foldery tego chomika:

Zgłoś jeśli naruszono regulamin