Picking The HU64 Mercedes Lock using the Lishi 2in1 Pick (1)(1).pdf

(665 KB) Pobierz
Picking The HU64
Mercedes Lock using the
Lishi 2in1 Pick/Decoder
The Mercedes HU64 lock is a straightforward pick and decode process using the lishi 2in1 tool , door
locks being far simpler to defeat than boot locks .
The lock is a 10 wafer lock with 5 cut heights referred to as heights 1 to 5 , 1 being the highest lift
and 5 being the lowest lift , all 10 cuts are found in the door lock and in the boot lock.
You will notice that the tool has the 10 wafer positions , in 2 rows of 5 , an upper row and a lower
row and follows a traditional 1 up and 1 down format . the grid to the right is the cut heights which
will be obvious in the decode section of this guide.
There are no proven picking sequences with this lock at present , so its a matter of finding the binding
wafer and picking it until bouncing tightly, until all wafers are picked and the lock opens .
The HU64 lock picks easiest in the locking direction and is a double lifter design of tool, and requires
the lightest of tension for consistent success .
Excessive tension and overlifting is the most common cause of failure with this lock , the more tension
thats applied the higher the liklyhood of overlifting and the more likelyhood of damage to your tool ,
so very light tension is required for this tool.
Picking the HU64 lock
Fully insert the tool into the lock , apply a light tension and move one of the lifters to the first wafer ,
gently lift the wafer half a mm , if it moves then leave it alone and move on , try the next , any
movement in the wafer at all , then leave it alone. When you find a binding wafer, lift until it has free
movement again, a tight bounce i refer to as slapping. Every time you find a binding wafer , pick it
until it slaps . once all binding wafers are set , the lock will open.
It is not unusual for a set wafer to drop out during the pick process , so expect to find a previously set
wafer to bind again even after picking already .
A picture guide of the picking process is below.
Insert the tool fully and apply a light tension
Position 1 is the first to bind and pick
Position 3 is the next to bind and pick
Position 5 is the next to bind and pick
Position 9 is the next to bind and pick
Position 4 is the next to bind and pick
Position 6 is the next to bind and pick
Position 8 is the next to bind and pick

Plik z chomika:

Inne pliki z tego folderu:

Inne foldery tego chomika:

Zgłoś jeśli naruszono regulamin